Nidec NE200 Series - Page 42

NE200&300 Quick Start Guide
41
Code Description Setting range Default Modify
Modbus
Address
terminal
function
selection
23: Acc./Dec. time
selector 2
24: Running pause
normally open
25: Running pause
normally closed
26: External fault
normally open
27: External fault
normally closed
28: Run command
switch to terminal
29: Run command
switch to keypad
30: External stop
terminal; same to
STOP key in keypad
control mode.
31: Reserved
32: PLC status reset
33: Wobble freq.
pause
34: Wobble freq.
status reset
35: PID pause
36: PID parameters
switching
37: PID direction
reversion; Active this
terminal to reverse
PID direction set by
F8.04.
38: Timing drive input
39: Counter signal
input
40: Counter clear
F6.09
②
Reserve
③ AI1
terminal
function
selection
Reserved ×
0709H