Nidec NE200 Series - Group FP Protection Parameters

NE200&300 Quick Start Guide
65
Code Description Setting range Default Modify
Modbus
Address
FF.10 Reserved Reserved Reserved - 100AH
FF.11
Software
version
number of
control board
1.00~10.00 1 - 100BH
FF.12
Non-standard
version
number of
software
0~255 0 - 100CH
FF.13
②
Heat sink
temperature
-30.0 ～ 120.0°C 0.0°C - 100DH
③
IGBT
temperature
0.0 ～ 140.0°C 0.0°C - 100DH
FF.14
②
Flux
current
-200.0~200.0% * 100EH
FF.15
③
Torque
current
-200.0~200.0% * 100FH
FF.17
Accumulated
kilowatt-hours
（ Upper 16
bits ）
0~65535kWH 0kWH - 1011H
FF.18
Accumulated
kilowatt-hours
（ Low 16
bits ）
0~65535kWH 0kWH - 1012H
Group FP Protection Parameters
Code Description Setting range Default Modify
Modbus
Address
FP.00
User
password
0~9999
0: No password
0 ○ -
Others: password
protection
FP.01
Parameter
write-in
protection
0: All parameters are
allowed modifying
0 ○ --
1: Only FP.01 and FP.03
can be modified