INTRODUCTION SPDM CONTROL BOX
NIDEC ASI S.P.A. – SPDM CONTROL BOX USER MANUAL
10 IMSPDCB2EN
SPDM CONTROL BOX MANAGEMENT
Only experienced and qualified personnel with adequate knowledge in the electrical, electronic and mechanical fields, who are authorised and
duly trained and are aware of all the risks regarding low and medium voltage equipment can manage the SPDM CONTROL BOX, which
includes incorporation/installation, operation, use, maintenance, cleaning, disassembly and dismantling.
Personnel in charge of incorporation/installation, operation of the SPDM CONTROL BOX must be aware that knowing and applying the safety
rules is an integral part of their tasks.
The definition of an experienced person and of a designated person for managing the electrical systems is as per the EN 50110-1 standard, to
which reference must be made for further details.
In accordance with the EN 50110-1 standard, unauthorised and unqualified personnel cannot access the area where the SPDM CONTROL
BOX is installed
Perform the following operations before starting to use the SPDM CONTROL BOX:
Read this User and Maintenance Manual and the related documentation (chap. 9) carefully
Make sure the SPDM CONTROL BOX is fully incorporated/installed in the equipment or system for which it is intended
Make sure all of the necessary safety devices are present to ensure the equipment/system conforms with the instructions of the
applicable Directives
Know which safety devices and protections have been provided and are available in the SPDM CONTROL BOX, with their position
and function inside the equipment.
Do not start the SPDM CONTROL BOX unless the equipment/system/machinery into which it must be incorporated or installed has been
declared in compliance with the rules of Machinery Directive 2006/42/EC and of the Directives applicable to the equipment/system/machinery
in its entirety.
WARNING
The various safety devices and systems are listed in chapter 4.
HAZARD
Disconnecting or partially removing the safety protections positioned to protect against dangerous parts is prohibited.
Removing any danger, caution, prohibition, notice signs is prohibited.
Opening the electrical panels while they are operating or immediately after power has been disconnected is strictly prohibited. Wait at least 10
minutes before opening the electrical panels after having disconnected power.
All of the safety and protection devices must be maintained fully efficient in order to ensure they work properly. They must be immediately
repaired or replaced by the after-sales assistance centre in case of damage or malfunction.