SPDM CONTROL BOX 2 – COMPOSITION
NIDEC ASI S.P.A. – SPDM CONTROL BOX USER MANUAL
IMSPDCB2EN 25
P5 +5 V supply voltage test point; adjusted by trimmer P3.
GND Control circuit 0V test point.
N15 - 15 V supply voltage test point; adjusted by trimmer P2.
N15s - 15 V held supply voltage test point.
N24 - 24 V supply voltage test point.
N24F - 24 V filtered supply voltage test point.
Power supply board “GAAPA” (cod. 1000080550)2.8
The board named “GAAPA” is supplied by a 24V dc
switched mode power supply and gives at its outputs
all the voltages necessary for the operation of the
SYSTEM2 plus the SYSENC boards.
GAAPA is mounted on the back of the control box.
The GAAPA has a protection fuse of 6.3A, 250V.
To Next Page
Loading...
