4 - MAINTENANCE SPDM CONTROL BOX
NIDEC ASI S.P.A. – SPDM CONTROL BOX USER MANUAL
48 IMSPDCB2EN
Saving drive parameter values
The Next and Finish button are initially disabled. You have to
provide the correct drive IP address in the IP Address text box. To
start the save process just click on the Save Parameter Values
button.
Fig. 4.4-4 - Saving drive parameter values. Type IP address
The ongoing process is notified by a progress bar and a messages
output area. You have to wait a few seconds for the process to
complete.
The procedure will try to save parameter values
based on the configuration provided by the modules you have
selected to install. Maybe some parameter does not exist in the pre-
existing Drive configuration and a read error will be logged. This is
usually not an error.
Fig. 4.4-5 - Saving drive parameter values. Ongoing process
When the process finish, you will be able to read the operation log in
the message output area.
You can click on the OK button to continue the procedure.
Fig. 4.4-6 - Saving Drive parameter values. Operation Done
Downloading the Firmware
In this step you will be asked to download the firmware. This is a “no
rollback” process so you have to do it only if you are sure of what
you are doing. If you previously saved the parameter values the IP
address field should be already filled with the correct ip address,
otherwise please type in the correct ip. You can test if that ip
address is reachable by clicking on the Test button.
The fields User and Password are already filled with the correct
values. Leave them as they are.
Initially Next and Finish button are disabled. You have to click on
the red Download Firmware! button to proceed.
Fig. 4.4-7 - Download Firmware. OK to start
NOTE
To Next Page
Loading...
