Message
Flash is in TTL mode. Choose
another setting or use a CPU
lens.
No Bulb in S mode.
Unable to measure white
balance. Please try again.
Folder contains no images.
File does not contain image
data.
Check printer.
Error. Press shutter release
button again.
Initialization error. Contact
Nikon-authorized service rep-
resentative.
Viewfinder
(blinks)
(blinks)
(blinks)
b_Lb
(blinks)
(blinks)
(blinks)
Er'r
(blinks)
Err
(blinks)
Solution
Flash has fired at full power. View photo; if underex-
posed, adjust settings and try again.
• Built-in flash is lowered: raise buiINn flash.
• Flash head on optional SB400 Speedlight is in
bounce-flash position.
• SB-400 is unable to fully illuminate subject at cur-
rent lens focal length. Increase distance to subject
(this warning is not displayed with other optional
Speedlights).
20,45,
48, 50,
76, 78
34
gg
gg
Change flash control mode for optional Speedlight. 100
Change shutter speed or select mode M. 39-44
Camera unable to measure preset white balance.
47, 70
Adjust exposure settings and try again.
• Insert another memory card. 12
• Set Playback folder to All. 66
13,
Delete file or reformat memory card. 20, 65
Insert new ink or toner cartridge in printer. If error
occurs with ink remaining in printer, check printer 60
status.
Press shutter-release button again. If error persists,
X,
consult with Nikon-authodzed service representa- 16-17
rive.
Contact Nikon-authorized service representative, x
_ Help
A blinking [ is displayed in the monitor or viewfinder indicates that a description of the current prob
lem can be viewed by pressing the _ button.
112 TechnicalNotes/Troubleshooting
To Next Page
Loading...
Need help?
General
