441
n
Bright bands appear during live view or movie recording: A flashing sign, flash, or
other light source with brief duration was used during live view or movie
recording.
Noise (bright spots, randomly-spaced bright pixels, fog, lines, or reddish areas) appears in
photos:
• To reduce randomly-spaced bright pixels, fog, or lines, choose lower ISO
sensitivity or use high ISO noise reduction (0 117, 308).
• To reduce bright spots, randomly-spaced bright pixels, or fog at shutter
speeds slower than 1 s or to reduce reddish areas and other artifacts in
long time-exposures, enable long exposure noise reduction (0 308).
• Turn Active D-Lighting off to avoid heightening the effects of noise
(0 188).
Smudges appear in photographs: Clean front and rear lens elements.
If problem
persists, perform image sensor cleaning (0 417).
Colors are unnatural:
• Adjust white balance to match light source (0 155).
• Adjust Set Picture Control settings (0 177).
Can not measure white balance: Subject is too dark or too bright (0 165).
Image can not be selected as source for preset white balance: Image was not created
with D4S (0 172).
White balance bracketing unavailable:
• NEF (RAW) or NEF+JPEG image quality option selected for image quality
(0 90).
• Multiple exposure mode is in effect (0 214).
Photographs and movies do not appear to have the same exposure as the preview shown
in the monitor during live view: Changes to monitor brightness during live view
photography and movie live view have no effect on images recorded with
the camera (0 57).
Effects of Picture Control differ from image to image: A (auto) is selected for
sharpening, contrast, or saturation.
For consistent results over a series of
photographs, choose another setting (0 181).
Metering can not be changed: Autoexposure lock is in effect (0 137).
To Next Page
Loading...
