VBA10401-R.3623.A
- Ａ36 ･ -
②
Attach the communications tool temporarily to
the body A with the screw (6K010-049) which
is included in package.
③
Loosen the screw (6K010-049
)
and screw it
lightly again at the position where the shaft
C of the body can enter in the hole B of the
communications tool.
Note: Do NOT tighten screw completely.
How to connect communications tool (J61205)
①
Connect the communications tool (J61205)
to MC-31 (J19109).
J61205
J19109
④
Pinch the contact part of the connection FPC with
the communications tool to make a connection.
Connection
FPC
Ａ
Ｃ
Ｂ
6K010-049
⑤
Connection is completed.
＊
Note:
This tool is xed with just a one screw, so handle the
camera very carefully when the tool is attached.
To Next Page
Loading...
