VBA10401-R.3623.A
- Ａ56 ･ -
9-6. TFT-PCB EEPROM ashram up
・Provide the power for the camera via AC adapter.
・Set "PTP" mode by Setup menu.
・Connect the camera and PC via USB cable.
・Click "TFT PCB EEPROM FLASHRAM UP" of the menu on screen.
・The adjustment starts. When it is completed, "OK" is displayed.
9-7. Reading of RISC version
・Provide the power for the camera via AC adapter.
・Set "PTP" mode by Setup menu.
・Connect the camera and PC via USB cable.
・Click "READING OF RISC VERSION" of the menu on screen.
・RISC version is displayed.
10. Procedure for upgrading RISC rmware:
・ After preparing the CF card, copy the latest version ( XXXX. BIN) into the root directory.
・ Insert the CF card, and select "FIRMWARE VERSION" from the SETUP menu.
・ Follow the instructions on screen for version upgrading. It takes approx. 3-4 minutes.
・ Check the version of rmware by "RISC VERSION" of the image adjustment software.
Note:
In case incorrect les are included in the CF card, the details for upgrading are not displayed even
after selecting "FIRMWARE VERSION" from the SETUP menu.
To Next Page
Loading...
