Nikon D70 VBA10401 - Pixel Defect (Black Spots) Compensation; Pixel Defect (White Spots) Compensation

VBA10401-R.3623.A
- Ａ54 ･ -
9-2. Pixel defect (black spots) compensation
・Set the color viewer luminance to LV13 equiv.
・Provide the power for the camera via AC adapter.
・Reset "Custom setting".
・Set "PTP" mode by Setup menu.
・Set the focus mode to M, exposure mode to M, and the exposure compensation to "0" of the camera.
・Connect the camera and PC via USB cable.
・Click "CCD BLACK POINT DEFECT COMPENSATION" of the menu on screen.
・Attach the tool lens (Aperture F5.6) to the camera (without lter).
・Get the camera closest to the center of the illuminated surface of the color viewer.
・When the adjustment starts, pixel defects are detected, displaying the number of pixels and addresses.
・After conrming the above, click "X" button.
・When it is completed, "OK" is displayed.
9-3. Pixel defect (white spots) compensation
・Check the environmental temperature (approx. 20-25°C.).
・Provide the power for the camera via AC adapter.
・Reset "Custom setting".
・Set "PTP" mode by Setup menu.
・Set the focus mode to M, exposure mode to M, and the exposure compensation to "0" of the camera.
・Connect the camera and PC via USB cable.
・Click "CCD WHITE POINT DEFECT COMPENSATION" of the menu on screen.
・Cap the camera with the body cap or lens cap to shield light from the mount.
・When the adjustment starts, pixel defects are detected, displaying the number of pixels and addresses.
・After conrming the above, click "X" button.
・When it is completed, "OK" is displayed.
＊
Note: In some cases, NG occurs due to dusts on the CCD.
Be sure to clean the CCD surface before adjustments.