Nikon T-RCP - Selecting Optical Path; Selecting Condenser Module

II Basic Operation
3 Selecting Optical Path
- 26 -
3 Selecting Optical Path
Press the LIGHT PATH key to select an optical path.
Each LIGHT PATH key corresponds to one of the optical
paths; you can select an optical path by simply pressing
the key corresponding to the path.
LED INDICATION:
(1) The LED of the LIGHT PATH key corresponding to
the currently selected optical path is lit green.
(1)
Note:
If TE2000-U or TE2000-S is used, you cannot use the LIGHT PATH keys to select an optical path. Use optical
path switchover dial on the microscope instead.
4 Selecting Condenser Module
Press the CONDENSER key to turn the condenser module
changeover clockwise or counterclockwise to select a
condenser module.
Screen indication:
(1) The currently selected address in the condenser
module changeover is indicated.
(2) The name of the condenser module in the optical
path is indicated.
(1) (2)
Note:
If the condenser module changeover is not connected, the condenser module information will not be indicated on
the LCD.