Menu functions
48
Copyright © 2004 Nokia. All rights reserved
The settings are now saved and
you can make a connection to
the WAP service.
Making a connection to a
WAP service
First, activate the settings of the
WAP service that you want to use.
If you want to use the same WAP
service as the last time, you do not
need to activate its settings again.
To activate the settings:
1. In the Services menu, scroll to
Settings and press
(Select).
2. Scroll to Connection settings
and press (Select).
3. Scroll to the appropriate
setting set and press
(Options).
4. Scroll to Activate and press
(Select).
Next, make a connection to the
WAP service. Do one of the
following:
• Open the homepage of the
WAP service: In the Services
menu, scroll to Home and press
(Select). OR
• Start the connection in standby
mode: When you have not
typed in any characters on the
display, press and hold the
number key 0. OR
• Select a bookmark of the WAP
service: In the Services menu,
scroll to Bookmarks and press
(Select). Scroll to the
desired bookmark and press
(Options). Scroll to Go to
and press (Select).
Make sure that the currently
active set of connection
settings can be used with the
WAP page to which the
bookmark refers. If the
bookmark does not work (in
this case Check service
settings may be displayed),
change the set of connection
settings and try again. OR
• Enter the address of the WAP
service: In the Services menu,
scroll to Go to address and
press (Select). Type in the
address (press the Chr key for
special characters) of the WAP
service and press (OK).
Note that it is not necessary to
add the prefix http:// in front of
the address since it will be
added automatically. If you are
using a protocol other than
http (such as ftp), add the
appropriate prefix.
Your phone may have some pre-
installed "bookmarks" for sites not
affiliated with Nokia. Nokia does
not warrant or endorse these sites.
If you choose to access them, you
Maverik_apac.fm Page 48 Thursday, October 7, 2004 2:03 PM
To Next Page
Loading...
