Nokia 6090 - Adding Contacts to Phone Book

Nokia 6090 AT Command Set 11
&F Restore Factory Settings
This command restores all the factory settings including all the S-register settings but
does not save them. Command parameters that are reset to their factory defaults are:
S3, S4, S5, E, Q, V, X, &C, &D, +IFC, +ILRR, S25, &S, &Q, +CSCS, S0, S7, S8,
S10, +DS, +DR, +ES, +EB, +EFCS, +ER, +ETBM, S2, S12, +CSTA, +CMOD,
+CBST, +CRLP, +CR, +CRC, +CSNS, +CREG, +CLIP, +CLIR, +COLP, +CCUG,
+CCWA (only <n>), +CUSD (only <n>), +CSSN, +CMEC, +CPBS, +CMEE, +CSMS,
+CPMS, +CMGF, +CSCA, +CSMP, +CSDH, +CSCB, +CNMI.
Syntax:
AT&F[0]
Restore factory settings.
&K Select Flow Control
This command selects the local flow control mode. This command changes the same
setting as +IFC. Use of +IFC is recommended. (De facto.)
Syntax:
AT&K[0]
Disable flow control.
AT&K3
Set hardware flow control (CTS/RTS).
Default option.
AT&K4
Set software flow control (XON/XOFF)
&Q Define Communications Mode Option
This command defines the dialling and on-line options. (De facto.)
Syntax:
AT&Q[0]
Enable normal asynchronous operation.
Default option.
AT&Q2
Enable DTR controlled dial. DTR OFF to
ON causes a call to be made to the
number stored in the TA dial slot zero.
DTR ON to OFF hangs up the call.
&S Define DSR Option
This command defines how the DSR V.24 signal is handled. (De facto.)
Syntax:
AT&S[0]
Keep DSR always ON.
AT&S1 Enable normal DSR usage. Default
option.
&V View Active Configuration
This command displays the current values of the S-registers. (V.25ter)
Syntax:
AT&V[0]
View active configuration. (All command
parameter values defined under &F and
&Y settings).
AT&V1
Show settings in stored profile 0. (All
command parameter values defined under
&W).
AT&V2
Show settings in stored profile 1. (All
command parameter values defined under
&W).
Response is for V1 and V2:
E1 Q0 V1 X5 &C1 &D2 &Q0 &S1
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S07:060 S08:002
S10:100 S12:050 S14:010 S21:112 S22:016 S25:000 S27:000 S34:002
S35:007 S38:000 S39:000 S40:000 S41:001 S42:061 S43:061 S44:048
S45:006 S46:000 S47:000 S48:000