Nokia 6090 - 4. Using the Menu; Menu Navigation: Scrolling; Menu Navigation: Shortcuts

Nokia 6090 AT Command Set 17
+CCUG Closed User Group
Selects CUG information to be sent to network with dial command D (see page 58).
(GSM 07.07)
Syntax:
AT+CCUG=[<n>[,<index>[,<info>]]]
Default option is 0,0,0.
AT+CCUG?
Query current setting.
Response is +CCUG: <n>,<index>,<info>
AT+CCUG=?
OK
Parameters:
<n>:
0
disable CUG temporary mode
1
enable CUG temporary mode
<index>:
0…9
CUG index
<info>:
0
no information
1
suppress OA
+CCWA Call Waiting
This command allows control of the call waiting supplementary service and
presentation of +CCWA unsolicited result code according to GSM 02.83. When
status request response from network indicates that SS is active for specific data
bearer services (e.g. 'circuit async'), AT interface indicates only 'data' (=2) ('not
active' case is displayed only when SS is not active to any service; i.e. +CCWA: 0,7).
(GSM 07.07)
Syntax:
AT+CCWA=[<n>[,
<mode>[,<class>]]]
When <mode>=2: the response is
+CCWA: <status>,<class1>
[<CR><LF>+CCWA: <status>,<class2>
[...]] Default option is 0[,,7].
AT+CCWA?
Query current setting.
Response is +CCWA:<n>
AT+CCWA=?
Show supported values.
Response is +CCWA:(list of supported
<n>'s).
Parameters:
<n>
(sets/shows the result code presentation
status in the TA):
0
disable
1
enable
<mode>
(when <mode> parameter is not given,
network is not interrogated):
0
disable
1
enable
2
query status
<classx>
is a sum of integers each representing a
class of information (default 7 equals to all
classes):
1
voice
2
data
4
fax
also all other values below 128 are
reserved
<status>:
0
not active
1
active