Nokia 6090 - COLP Connected Line Identification Presentation; COPS Operator Selection

Nokia 6090 AT Command Set 35
+COLP Connected Line Identification Presentation
Controls presentation of +COLP intermediate result code or returns COLP
subscription status from network. Nokia 6090 does not support network status query,
<m> equals always 2. (GSM 07.07)
Syntax:
AT+COLP=[<n>] Select bearer service type. Default
option is 0.
AT+COLP?
Query current setting.
Response is +COLP: <n>,<m>
AT+COLP=?
Show supported values.
Response is +COLP: (list of supported
<n>'s).
Parameters:
<n >:
parameter sets/shows the result code
presentation status in the TA:
0
disable
1
enable
<m >:
parameter shows the subscriber COLP
service status in the network:
2
unknown (e.g. no network, etc.)
+COPS Operator selection
Set command forces an attempt to select and register the GSM network operator.
<mode> is used to select whether the selection is done automatically by the Nokia
6090 or is forced by this command to operator <oper>, which is given in format
<format>.
Important note: This feature is avaible in 5.300 SW or later.
Syntax:
AT+COPS=[<mode>[,<format>[,<oper>]
]]
select operator
AT+COPS?
Query current setting.
Response is +COPS:
<mode>[,<format>,<oper>]
AT+COLP=?
Show supported values.
Response is +COLP: [(list of supported
<stat>), numeric<oper>] [,, (list of
supported <mode>'s), (list of supported
<format>'s)].
Parameters:
<mode>:
network mode, which is choose to select
the network
0
automatic (<oper> field is ignored)
1
manual (<oper> shall be presented)
<format>:
parameter shows the network operator
code:
2
numeric <oper>
<oper>:
network operator code
<stat>:
Availability of the operator
0
unknown
1
available
2
current
3
forbidden
Examples:
AT+COPS=1,2,”26202”