Nokia 6090 - O Return to On-Line Data State; P Select Pulse Dialling; Q Result Code Suppression; S0 Automatic Answer

Nokia 6090 AT Command Set 61
O Return to On-Line Data State
This command is used when you have made a connection with the remote device
and have escaped (with the +++ command) to the command mode. Give the
command to return from the (on-line) command mode to normal on-line operation.
(V.25ter)
Syntax:
ATO[<n>]
Go to on-line state. Response is
CONNECT [<speed>].
Result Codes
Possible verbose
result codes (V1)
Numeric
(V0) Description
CONNECT
1 data/fax call established; rate 300 bps (or X
forbids rate display)
CONNECT 1200
5 data/fax call established; rate 1200 bps
CONNECT 2400 10 data/fax call established; rate 2400 bps
CONNECT 4800 11 data/fax call established; rate 4800 bps
CONNECT 9600 12 data/fax call established; rate 9600 bps
ERROR 4 command cannot be actioned
NO CARRIER 3 call could not be established
OK 0 command aborted
P Select Pulse Dialling
This setting is ignored. It is included for compatibility reasons. (V.25ter)
Syntax:
ATP
Q Result Code Suppression
This command determines whether responses are sent to the DTE or not. Affects
only result codes, not information responses. (V.25ter)
Syntax:
ATQ[0]
Enable sending of responses to DTE.
Default option.
ATQ1
Disable sending of responses to DTE
S0 Automatic Answer
Value indicates number of rings (RING or +CRING result codes) to wait before
answering automatically. Value 0 disables auto-answer. (V.25ter)
Syntax:
ATS0=<n>
Values for <n> are 0..255 (default 0).
ATS0?
Query current setting.
Response is <n>.
S1 Ring Count
Returns number of rings (RING or +CRING result codes) counted after last MT call
setup. (De facto.)
Syntax:
ATS1?
Query current setting.
Response is <n>. Values for <n> are
000..255.