Nokia 6090 - S7 Connection Completion Timeout; S8 Comma Dial Modifier Time; S10 Automatic Disconnect Delay; S12 Escape Guard Time

Nokia 6090 AT Command Set 63
S7 Connection Completion Timeout
Also known as 'no answer timeout'. Value is given in seconds. Value 0 (unlimited
time) is not in V.25ter. (V.25ter).
Syntax:
ATS7=<n>
Values for <n> are 0..255 (default 60).
ATS7?
Query current setting.
Response is <n>.
S8 Comma Dial Modifier Time
Value is given in seconds. See also command D, page 58. (V.25ter)
Syntax:
ATS8=<n>
Values for <n> are 0..255 (default 2).
ATS8?
Query current setting.
Response is <n>.
S10 Automatic Disconnect Delay
Value is given in tenths of a second. Values 0 and 255 (do not disconnect) are not in
V.25ter. (V.25ter)
Syntax:
ATS10=<n>
Values for <n> are 0..255 (default 100).
ATS10?
Query current setting.
Response is <n>.
S12 Escape Guard Time
Value is in fiftieths of a second (default is one second). See also the command +++
Escape at page 12. (De facto.)
Syntax:
ATS12=<n>
Values for <n> are 0..255 (default 50).
ATS12?
Query current setting.
Response is <n>.
S25 Detect DTR Change Time
Time (in seconds) to react on DTR signal change. See also command &D, page 10.
(De facto.)
Syntax:
ATS25=<n>
Set DTR change time. Default is 0.
ATS25?
Show valid values. Response is <n>.
Values for <n>:
000
...
255
S46 Force V.42bis Data Compression
Used to force V.42bis on for mobile to mobile connections. 0=disabled, 1=enabled in
transmit direction only, 2=enabled in receive direction only, 3=enabled in both
directions.
Syntax:
ATS46=<n>
Values for <n>: 0..3 (default 0)
ATS46?
Values for <n>: 000..003