Nokia 6090 - ILRR DTE-DCE Local Rate Report; De Facto Result Codes; Call Repeat Restriction Result Codes; CARRIER Error Control Negotiation Start

Nokia 6090 AT Command Set 78
Copyright © 2001. Nokia Mobile Phones. All rights reserved.
+ILRR DTE-DCE Local Rate Report
+ILRR: <rate>[,<rxRate>]
is given when +ILRR=1; informs about the local port rate after connection
establishment.
The <rxRate> parameter is not needed by Nokia 6090. This intermediate result code
is given after (possible) +DR result code. (V.25ter).
See details about this command page 56
De Facto Result Codes
Call Repeat Restriction Result Codes
BLACKLISTED and DELAYED. See dialling command D, page 58.
This mechanism is mandatory. (GSM 02.07 Annex A).
CARRIER Error Control Negotiation Start
This code is given after (possible) +COLP result code during MO data call setup.
During MT data call setup this is the first intermediate result code. Note that if +CR
result code sending is active, it shall replace this code. See also command X, page
64.
GSM 07.07 Result Codes
+CCWA Call Waiting
+CCWA: <number>,<type>,<class>[,<alpha>]
is given when +CCWA=1 and incoming MT call is received when there is active or
held calls in ME (discarded if in on-line data state and V.80 in-band mode is disabled
or not supported).
Note that this result code is not repeated similarly as RING, but given only once.
Alpha not supported by Nokia 6090. (GSM 07.07).
See details about this command page 17
+CIEV Indicator Event
+CIEV: <ind>,<value>
is given when +CMER <ind> value is 1 and a indicator on the ME display is changed.
Important note: This feature is avaible in 5.300 SW or later.
See details about this command page 26
+CKEV Keypress Indication
+CKEV: <key>,<press>
is given when +CMER <keyp> value is 2 and a key on the ME keyboard is pressed.
Important note: This feature is avaible in 5.300 SW or later.
See details about this command page 26
+CLIP Calling Line Identification Report
+CLIP: <number>,<type>[, <subaddr>,<satype>[,<alpha>]]
is given when +CLIP=1 and number received from network when MT call received
(no active or held calls in ME).
This result code is sent to TE after every RING (or +CRING) result code. Subaddress
and alpha not supported by Nokia 6090. (GSM 07.07).