Nokia 6090 AT Command Set 15
+CCFC Call Forwarding Number and Conditions
This commands allows control of the call forwarding supplementary service according
to GSM 02.82.. <reason> values 4 and 5 are only applicable for <mode>=0. When
status request response from network indicates that SS is active for specific data
bearer services (e.g. 'circuit async'), AT interface indicates only 'data' (<class>=2)
('not active' case is displayed only when SS is not active to any service; i.e. +CCFC:
0,7). (GSM 07.07)
Syntax:
AT+CCFC=<reason>,
<mode>[,<number>
[,<type>[,<class>
[,<subaddr>
[,<satype>[, <time>]]]]]
When <mode>=2 the response is +CCFC:
<status>,<class1>[,<number>,<type>
[,<subaddr>,<satype>[,<time>]]]
[<CR><LF>+CCFC:
<status>,<class2>[,<number>
,<type>[,<subaddr>,<satype>[,<time>]]]
[...]].
Default option is [,,, 129/145,7 ,,128,20]
AT+CCFC=?
Show supported <reason>’s.
Parameters:
<reason>:
0
unconditional
1
mobile busy
2
no reply
3
not reachable
4
all call forwarding (GSM 02.30)
5
all conditional call forwarding (GSM 02.30)
<mode>:
0
disable
1
enable
2
query status
3
registration
4
erasure
<number>: string type phone number of forwarding address in format specified by
<type>
<type>: type of address octet in integer format (GSM 04.08); default 145 when
dialling string includes international access code character "+", otherwise 129
<class> is a sum of integers each representing a class of information (default 7
equals to all classes):
1
voice
2
data
4
fax
also all other values below 128 are reserved
<subaddr>: string type subaddress of format specified by <satype>
<satype>: type of subaddress octet in integer format (GSM 04.08), default 128
<time>: 1...30 when "no reply" is enabled or queried, this gives the time in seconds
to wait before call is forwarded, default value 20
<status>:
0
not active
1
active
Examples:
AT+CCFC=1,2
Queries the status of “mobile busy” (i.e. the mobile is on, a call is active but the
user/network turned off the “Call waiting service”)
Response:
+CCFC: 1,1,"+499501231234 ",145