EasyManua.ls Logo

Nokia 6090 - Gsm 07.05 Result Codes; CBM New CBM; CDS New SMS-STATUS-REPORT; CDSI New SMS-STATUS-REPORT Indication

Nokia 6090
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Nokia 6090 AT Command Set 81
Copyright © 2001. Nokia Mobile Phones. All rights reserved.
Note that only the first 'request' message during a network initiated USSD session
yields to this unsolicited result code. Rests are information responses of +CUSD
command. (GSM 07.07)
See details about this command page 50.
GSM 07.05 Result Codes
+CBM New CBM
text mode:
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data>
PDU mode:
+CBM: <length><CR><LF><pdu>
- when +CNMI=0:
messages are discarded
- when +CNMI=1-2:
messages are forwarded directly to TE (CBMs cannot be received during a call)
See also command +CNMI, page 34. (GSM 07.05).
See details about +CBM page 50.
+CDS New SMS-STATUS-REPORT
text mode:
+CDS: <fo>,<mr>,[<ra>],[<tora>], <scts>,<dt>,<st>
PDU mode:
+CDS: <length><CR><LF><pdu>
- when +CNMI=0:
routed messages are buffered into TA/ME (if buffer is full, 'memory capacity
exceeded' is sent to network)
- when +CNMI=1:
in on-line data state routed messages are rejected (e.g. 'memory capacity exceeded'
is sent to network and when command mode is entered 'memory available' is sent to
network); in command mode forwarded directly to TE
- when +CNMI=2:
in on-line data state routed messages are buffered into TA/ME (if buffer is full,
'memory capacity exceeded' is sent to network and when command mode is entered
'memory available' should be sent to network); in command mode forwarded directly
to TE
See also command +CNMI, page 34. (GSM 07.05).
+CDSI New SMS-STATUS-REPORT Indication
+CDSI: <mem>,<index>
- when +CNMI=0:
indications are buffered into TA/ME
- when +CNMI=1:
in on-line data state indications are discarded; in command mode forwarded directly
to TE
- when +CNMI=2:
in on-line data state indications are buffered into TA/ME; in command mode
forwarded directly to TE
See also command +CNMI, page 34. (GSM 07.05).
+CMS ERROR Message Service Failure
+CMS ERROR: <err>
given instead of ERROR when error is related to ME or network operation
See also the Error Values section, page 68. (GSM 07.05).

Table of Contents

Other manuals for Nokia 6090

Related product manuals