Nokia 6090 AT Command Set 33
2
alternating voice/data (bearer service 61)
3
voice followed by data (bearer service 81)
+CMSS Send Message from Storage
This command sends a message with the location value <index> from a preferred
message storage selected with AT+CPMS command (see page 41). If a new
recipient address <da> is given, it shall be used instead of the one stored with the
message. Reference value <mr> is returned to DTE on successful message delivery.
(GSM 07.05)
Syntax:
AT+CMSS=<index>[, <da>[,<toda>]]
Responses:
text mode (+CMGF=1) and sending ok:
+CMSS: <mr>[,<scts>]
PDU mode (+CMGF=0) and sending ok:
+CMSS: <mr>[,<ackpdu>]
: [,"",129/145]
AT+CMSS=?
OK
Parameters:
<index>
location number
<mr>
message reference number
<da>
destination address
<toda>
type of destination address, 129 for
normal and 145 for international access
('+' character automatically added to
address)
Example:
AT+CMSS=1
Sends the message on index 1 to the da address, which is in the message.
Response:
+CMSS: <mr>
You have successfully sent this message.
+CNMA New Message Acknowledgement to ME/TA
This command confirms correct reception of a new message (SMS-DELIVER or
SMS-STATUS-REPORT) which is routed directly to the TE. This acknowledgement
command (causing ME to send RP-ACK to the network) is used when +CSMS (see
page 48) parameter <service> equals 1. TA does not send another +CMT or +CDS
result code to TE before previous one is acknowledged. If ME does not get
acknowledgement within required time (network timeout), ME send RP-ERROR to
the network. ME/TA automatically disable routing to TE by setting both <mt> and
<ds> values of +CNMI to zero. (GSM 07.05 PDU entering as specified in GSM
07.05).
Syntax:
text mode (+CMGF=1):
AT+CNMA
PDU mode (+CMGF=0):
AT+CNMA[=<n>[,<length>[<CR>
PDU is given<ctrl-Z/ESC>]]]
AT+CNMA=?
Show supported values.
Response for PDU mode (+CMGF=0) is:
+CNMA: (0-2)
Parameter:
<n>:
0
command operates similarly as defined for
the tect mode
1
send RP-ACK
2
send RP-Error
To Next Page
Loading...
