Nokia 6090 - Messages; Inbox Message Access; Composing and Sending Messages

Nokia 6090 AT Command Set 22
Examples:
AT+CKPD="D"
Simulation of keypress down as if was done by the human user of the phone. For
example it can be used to change the volume during a call.
AT+CKPD="\5B911"
This keypress combination causes the Nokia 6090 to go to Menu 9-1-1.
AT+CKPD="vV\56\76"
This keypress combination causes the Nokia 6090 to activate the down arrow
keypress four times.
AT+CKPD="m9221"
Change the currently selected ringing tone to "Wiliam Tell" ringing tone.
AT+CKPD="m915"
Mute the ringing tone.
AT+CKPD="c",10
Makes the Nokia 6090 go back to the idle display state from any sub-menu.
This command simulates the “c” keypress with a duration of one second.
+CLCC List Current Calls
Returns list of currently available calls in ME. (GSM 07.07)
Syntax:
AT+CLCC
Response is [+CLCC: <id1>, <dir>,
<stat>, <mode>, <mpty>[,,,<alpha>]
[<CR><LF>+CLCC: <id2>, <dir>, <stat>,
<mode>, <mpty> [,,,<alpha>] [...]]]
AT+CLCC=?
OK
Parameters:
<idx>: integer type; call identification number as described in GSM 02.30; this
number can be used in +CHLD command operations
<dir>:
0
mobile originated (MO) call
1
mobile terminated (MT) call
<stat> (state of call):
0
active
1
held
2
dialling (MO call)
3
alerting (MO call)
4
incoming (MT call)
5
waiting (MT call)
<mode> (bearer/teleservice):
0
voice
1
data
2
fax
3
voice followed by data, voice mode
4
alternating voice/data, voice mode
5
alternating voice/fax, voice mode
6
voice followed by data, data mode
7
alternating voice/data, data mode
8
alternating voice/fax, fax mode
9
unknown
<mpty>:
0
call is not one of multiparty (conference)
call parties
1
call is one of multiparty (conference) call