Nokia 6090 - E Command Echo; Fax Commands; H Hang up Call; I Request Identification Information

Nokia 6090 AT Command Set 60
E Command Echo
This command determines whether characters that are received from the DTE are
echoed or not in the command mode. (V.25ter)
Syntax:
ATE[0]
Disable echoing
ATE1 Enable echoing. Default option.
Fax Commands
The following fax (+F) command sets are available for use by the Nokia 6090 that
supports GSM 03.45 facsimile group 3 transparent:
• Class 1, TIA-578-A
• Class 2, TIA SP-2388
• Class 2.0, TIA-592 and ITU-T T.32
Error correction mode (ECM) in Class 2 and 2.0 is supported.
H Hang Up Call
This command normally hangs up the call. If the alternating call data mode is
currently active, ATH does not hang up the call but call mode is switched from data to
voice. If you want to disconnect the alternating call, you must use the AT+CHUP
command instead. (V.25ter)
Syntax:
ATH[<n>]
Hang up call. <n>=0
I Request Identification Information
This command displays information on the TA. (V.25ter)
Syntax:
ATI[0]
Displays the TA manufacturer
identification (same as for +GMI).
Response is Nokia Mobile Phones
ATI1
Displays the product serial number (same
as for +GSN).
ATI2
Displays the product version (same as for
+GMR).
ATI3
Displays the product name (same as for
+GMM).
Response is Nokia 6090 - GSM900 Fixed
Mobile Phone
ATI4...ATI13
Dummy values that are just accepted.
L Monitor Speaker Loudness
This setting is ignored. It is included for compatibility reasons. (V.)
Syntax:
ATL[<n>]
L[0]...L3
M Monitor Speaker Mode
This setting is ignored. It is included for compatibility reasons. (V.25ter)
Syntax:
ATM[<n>]
M[0]...M2