Nokia 6090 - Page 61

Nokia 6090 AT Command Set 59
in case of SIM ADN memory (SM) also
D>SIM shall be accepted (due to
inconsistency in 07.07).
ATD><n> [;]
Dials a stored number from a data
software memory location <n>.
ATD[;]
Dials a stored number from a data
software memory location 0.
ATD> <string>
Dial a number assigned to name <string>.
ATDL
Redials the last number that has been
dialled during the current session.
<dial-string> Characters
<dial-string> characters Values Description
V.25ter dialling digits
0123456789+ accepted as valid digits
*#ABCD cause ERROR
V.25ter modifiers , in case of voice call: originate call to
the number preceding comma, wait for
remote answer, pause for length
specified with S8 register, and send
numbers after comma as DTMF digits;
further commas cause pause for
length specified with S8 register (all
commas are ignored in case of data
call)
T P ! W @ accepted but ignored
V.25ter semicolon ; voice call originating (must be last
character in command line)
GSM 07.07 modifiers > direct dialling from phonebook (must
be first char after D) (see next table)
i allow calling line id presentation for
this call
I restrict calling line id presentation for
this call
G control CUG information for this call;
use +CCUG values
de facto L redial to the number last dialled
See also 07.07 and V.25ter. For voice call example refer 07.07 annex G. Note that I
is the only case-sensitive dial-string character.
Result Codes
All result codes are not in V.25ter. Before one of the above codes may be returned
some of the following: +CSSI, +COLP, +CR (or CARRIER), +ER, +DR, or +ILRR (in
that order).
Possible verbose
result codes (V1)
Numeric
(V0) Description
BLACKLISTED
14 call to the number is forbidden until manual reset
BUSY 7 called party is busy
CONNECT 1 data/fax call established; rate 300 bps (or X
forbids rate display)
CONNECT 1200
5 data/fax call established; rate 1200 bps
CONNECT 2400 10 data/fax call established; rate 2400 bps
CONNECT 4800 11 data/fax call established; rate 4800 bps
CONNECT 9600 12 data/fax call established; rate 9600 bps
DELAYED 13 call to the number is temporarily (5 sec - 3 min)
forbidden
ERROR
4 command cannot be actioned
NO ANSWER 8 called party does not answer
NO CARRIER 3 call could not be established
OK 0 command aborted or voice call started with
semicolon character