Nokia 6090 - CMGW Write Message to Memory

Nokia 6090 AT Command Set 31
Parameters:
<length>
length of the actual PDU in octets
<pdu>
service centre address followed by GSM
03.40 Protocol Data Unit in hexadecimal
format
<mr>
message reference number
Example:
AT+CMGF=1;+CMGS="0067800987666”
Sets the phone to “text mode” and begins to send a message to 0067800987666.
Response:
>
Enter now the data you want to send, like:
Hello, this is a SMS originated from a computer.<ctrl-Z >
Response:
+CMGS: <mr>
You have successfully sent a message.
(The right network SMSC must be set in the ME or set via +CSCA command)
+CMGW Write Message to Memory
This command stores a message in a preferred memory storage selected with
AT+CPMS command. Memory location of a stored message is returned. By default,
message status will be set to "STO UNSENT", but parameter also allows other status
values to be given. Entering of text is done similarly as specified in command
+CMGS Send Message (see page 30). If writing fails, final result code +CMS
ERROR: <err> is returned.
Syntax:
text mode (+CMGF=1):
AT+CMGW[=<oa/da>[,<tooa/toda>[,
<stat>]]]<CR>
text is entered <ctrl-Z/ESC>
Response for successful storing:
+CMGW: <index>
Default option: [,129/145, "STO
UNSENT"]
PDU mode (+CMGF=0):
AT+CMGW=<length>[,<stat>]<CR>
PDU is given <ctrl-Z/ESC>
Response for successful storing:
+CMGW: <index>
Default option: [,2]
AT+CMGW=?
OK
Parameters:
<addr>
origin or destination address
<type>
type of origin or destination
address,
129 for normal and 145 for
international access (number
contains '+' character)
<stat>
"REC UNREAD" received unread message
"REC READ" received read message
"STO UNSENT" stored unsent message (default)
"STO SENT" stored sent message
<index>
location number
Example:
AT+CMGF=1;+CMGW="+499501231234”
Sets the phone to “text mode” and begins to store a message to +499501231234
destination number.
Response:
>
Enter now the data you want to send, like:
This is an unsent SMS on my SIM from my computer.<ctrl-Z >