Nokia 6090 - S2 Escape Code Character; S3 Command Line Termination Character; S4 Response Formatting Character; S5 Command Line Editing Character

Nokia 6090 AT Command Set 62
S2 Escape Code Character
The default character is a plus sign. See also the command +++ Escape at page 12.
(De facto.) The decimal value representing the ASCII value of the new escape
character should be given as parameter <n>.
Syntax:
ATS2=<n>
Values for <n>are 0..127 (default 43)
ATS2?
Query current setting.
Response is <n>.
S3 Command Line Termination Character
Default character is carriage return. The setting is also used in result code and
information response formatting. See also command V, page 64. (V.25ter)
Syntax:
ATS3=<n>
Set termination character. Default is 13.
ATS3?
Show valid values. Response is <n>.
Values for <n>:
000
...
127
S4 Response Formatting Character
Default character is line feed. See also command V, page 64. (V.25ter)
Syntax:
ATS4=<n>
Set response formatting character. Default
is 10.
ATS4?
Show valid values. Response is <n>.
Values for <n>:
000
...
127
S5 Command Line Editing Character
Default character is backspace. (V.25ter)
Syntax:
ATS5=<n>
Set response formatting character.
Default is 8.
ATS5?
Show valid values. Response is <n>.
Values for <n>:
000
...
127
S6 Pause Before Blind Dialling
This setting is ignored. (V.25ter)
Syntax:
ATS6=<n>
Values for <n> are 2..10.
ATS6?
Query current setting.
Response is <n>.