Nokia 6090 - CME ERROR Mobile Equipment Error; COLP Connected Line Identification Report; CR Data Service Report; CREG Network Registration

Nokia 6090 AT Command Set 79
Copyright © 2001. Nokia Mobile Phones. All rights reserved.
See details about this command page 25
+CME ERROR Mobile Equipment Error
+CME ERROR: <err>
is given instead of ERROR when +CMEE=1 or =2 and error is related to ME or
network operation.
See also the Error Values section, page 68. (GSM 07.07)
+COLP Connected Line Identification Report
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]]
is given when +COLP=1 and number received from network when MO call
established.
This intermediate result code is given after (possible) +CSSI result code. Subaddress
and alpha not supported by Nokia 6090. (GSM 07.07) .
See details about this command page 35.
+CR Data service report
+CR: <type>
is given when +CR=1 and data call established; informs about the type of data call
being established.
This intermediate result code is given after (possible) +COLP result code during MO
data call setup. During MT data call setup this is the first intermediate result code.
Note that this result code shall replace CARRIER result code (when X5 is set). (GSM
07.07).
See details about this command page 42.
+CREG Network Registration
+CREG: <stat>[,<lac>,<cid>]
- when +CREG=1:
given when <stat> value changes; given after NO CARRIER if network lost when on-
line
- when +CREG=2:
given when <stat> value changes and when network cell (<lac> and <cid>) of ME
changes; given after NO CARRIER if network lost when on-line; if V.80 is enabled,
result code is sent in-band during on-line data mode (GSM 07.07).
See details about this command page 43.
+CRING Distinctive Ring
+CRING: <type>
is given when +CRC=1 and incoming MT call (no active or held calls in ME).
Note that this code replaces the V.25ter RING result code. (GSM 07.07).
See information about +CRC command page 42.
+CSSI Intermediate Supplementary Service Notification
+CSSI: <code1>[,<index>]
is given when +CSSN=1 and some supplementary service notification is given by
network during MO call establishment.
This is the first intermediate result code after dial command D. Supported <code1>'s
depend on the supplementary services implemented in a product. (GSM 07.07).
<code1>:
0
unconditional call forwarding is active
1
some of the conditional call forwardings