Nokia 6090 - CSDH Show Text Mode Parameters; CSMP Set Text Mode Parameters

Nokia 6090 AT Command Set 47
+CSDH Show Text Mode Parameters
This command controls whether detailed header information is shown in text mode
short message result codes. (GSM 07.05)
Syntax:
AT+CSDH=[<show>]
Enable or disable showing of detailed
header information.
Default setting is 0.
AT+CSDH?
Query current setting.
Response is +CSDH: <show>.
AT+CSDH=?
Show supported values.
Response is +CSDH:(list of supported
<show>'s).
Values for <show>:
0
do not show header values defined in
commands +CSCA and +CSMP (<sca>,
<tosca>, <fo>, <vp>, <pid> and <dcs>)
nor <length>, <toda> or <tooa> in +CMT,
+CMGL, +CMGR result codes for SMS-
DELIVERs and SMS-SUBMITs in text
mode; for SMS-COMMANDs in +CMGR
result code, do not show <pid>, <mn>,
<da>, <toda>, <length> or <cdata>
1
show all the values in result codes
+CSMP Set Text Mode Parameters
This command is used to select values for additional parameters needed when short
messages are sent, or stored. The parameters are only used in SMS text mode. The
values of these parameters may change also when +CRES is actioned. TA accepts
only valid SMS-SUBMIT and SMS-DELIVER values in <fo>. (GSM 07.05)
Syntax:
AT+CSMP=[<fo>[, <vp>[,
<pid>[, <dcs>]]]]
Set parameter values. Default setting is
17,167,0,0.
AT+CSMP?
Current setting query. Response is
+CSMP: <fo>, <vp>,<pid>, <dcs>.
AT+CSMP=?
OK
Parameters:
<fo> depending on the command or result code: first octet of SMS-
DELIVER, SMS-SUBMIT (default 17), or SMS-STATUS-REPORT in
integer format.
<vp> depending on SMS-SUBMIT setting: validity period either in integer
format (default 167) or in time-string format.
<pid> protocol identifier in integer format (default 0).
<dcs> SMS Data Coding Scheme (default 0).