Nokia 9000 - Printing

8-4 Printing
Printing
Documents can be directly printed only in Notes.
Printing is possible only to a printer that has an
IrDA compatible infrared port. To print to other
printers, transfer the file to a PC, as described in
chapter 10 "System: File transfer".
Please refer to the User’s Guide of the printer for
detailed safety instructions on the device.
To establish an infrared serial connection:
Make sure that the communicator’s infrared
port faces the infrared port of the printer.
Keep the infrared connection clear. In the
event the infrared connection is obstructed
for too long (for example, something is moved
between the infrared sensors or the commu-
nicator is moved), printing is interrupted.
To print a document, open the document, press
Print/Send
and select
Print
. For information on
the printers supported, read the
readme.txt
file
on the diskette supplied in the communicator
sales package, or see the Club.Nokia home page
in the World Wide Web (found at the address ht-
tp://www.club.nokia.com).
After the communicator has checked that you do
not already have an active PC connection, it
starts to scan for a printer. This means that you
cannot print while you are, for example, transfer-
ring files from the communicator to a PC. If the
printer cannot be found, a failure note is shown
and the editor view returns. If the correct printer
is found, the printer driver is selected automati-
cally and the printing view shows the name of
the document and the selected printer.
Press
Start
to start printing.
Printing problems
Though the communicator may detect a con-
nected printer, certain complications might still
occur.
If the printer found is not recognised:
Select the correct printer driver manually.
You can choose another printer after pressing
Printers
.
If the printer found is not recognised, and the
communicator does not have the correct driver
for the printer:
You can try to print the document using one
of the available printer drivers.
Notes settings
You can change the note editor’s default settings
by pressing the
Settings
command button in the
Notes main view. The settings are the default
values for note and fax editors’ text options and
margins, and they are valid until they are
changed again in the Settings view.
To change the settings, choose a setting and
press
Change
.
Font: URW Roman
/
URW Sans
(default) /
URW
Mono
Size: 10
points
/ 12
(default)
/ 14 / 18 / 24 / 36 /
user defined
Margins —
Opens a new view where you can de-
fine values for the following (the unit of measure
is chosen in the
Preferences
of the System appli-
cation’s settings):
Top margin
(default 2.54 cm / 1 inch)
Bottom margin
(default 2.54 cm / 1 inch)
Left margin
(default 2.54 cm / 1 inch)
Right margin
(default 2.54 cm / 1 inch)
notes.frm Page 4 Wednesday, January 15, 1997 12:48 PM