9-4 To-do list
application group), see chapter 11 "Extras: Clock
- Alarm clock".
The alarm options are
None (default) / At start
time / . . . minutes before event
(enter a value).
An active alarm is indicated by an icon in the Day
view (in the figure 9-2, the 15:00 o’clock event).
When the alarm occurs, an alarm note is shown
on both interface displays. The alarm sound can
be turned off by pressing any key. If you have set
the communicator to silent service (in the Sys-
tem application’s System settings), only the
alarm note will be shown.
To-do list
The To-do list is accessed by pressing the
To-do
list
command button in the Month view. The To-
do list is a list of tasks which must be completed
eventually, but are not connected to any specific
time or day. After a calendar alarm has occurred,
you have the opportunity to move the message
contents of the alarm to the To-do list by press-
ing the
Move to To
-
do list
command button.
The entries in the To-do list are numbered, and
they can be given high priority. High priority en-
tries are always shown at the top of the list (see
figure 9-3).
To change the status of the selected task, press
Mark as
. A pop-up box opens, and you can
change the status of the entry to
High priority
or
Normal priority
(default), or mark the task as
Completed
(as task number four in figure 9-3).
To create a new to-do task,
press
New
. A new
empty entry field is added at the end of the To-
do list.
To remove the currently selected entry from the
list, press
Delete
.
Figure 9-3
calendar.frm Page 4 Wednesday, January 15, 1997 2:12 PM
To Next Page
Loading...
