11-2 Clock
Pressing
Clear list
will erase previous calcula-
tions from the calculator tape. The maximum
number of characters per calculation is 100. The
maximum length of the calculator tape is 100
lines.
Clock
The Clock shows the time and date in your home
city and country, as well as in several other cities
and countries in the world. The Clock also in-
cludes an alarm clock.
The “Alarm active” symbol and time of the alarm
are shown only if an alarm is active.
Alarm clock
The Alarm clock is activated with the
Alarm
clock
command in the Clock main view. The
alarms will occur according to the home city
time (note this when in a different time zone, e.g.
when travelling abroad).
An alarm can be set to occur within the next 24
hours. Alarms that occur later than this are set in
the Calendar application.
When the alarm sounds, it can be turned off by
pressing any phone interface or communicator
interface key.
Press
+
or
-
to adjust the time shown in the
alarm clock display. Each press changes the
time by one minute, but if you hold the but-
ton down a while longer, the time will start to
change in steps of 15 minutes.
Press
OK
to accept the set alarm.
There can only be one active alarm. If an alarm is
already active, the command names are differ-
ent. A counter on the lower right side of the
screen shows how much time remains to the
time of the alarm.
Press
Change alarm time
if you want to read-
just the time of the alarm.
Press
Delete alarm
to cancel the alarm.
( ) parenthesis
= or Enter
sum
C
clears the entry field
Figure 11-2
extras.frm Page 2 Wednesday, January 15, 1997 1:34 PM
To Next Page
Loading...
