Nokia 9000 - Making a call

Chapter 14 - Phone interface 14-3
either delete or save the message. If you simply
listen to the message, the spool symbol will re-
main on the display. To play the message, press
Listen
.
Making a call
The communicator can make and receive calls
only when:
• The phone interface is switched on
•The communicator has a valid SIM card fitted
• The communicator is located in the service
area of the cellular network ( is shown)
Note:
Emergency calls to the international emer-
gency number 112 can usually be made without
the SIM card. Check with your network operator.
For more information about making emergency
calls, see chapter 1 "Introduction: Important
safety information - Emergency calls".

Key in the area code and the phone number of
the person you wish to call. If you make a
mistake, you can delete the digits one by one
by pressing repeatedly, or clear the whole
display by pressing and holding down the
key.
For international calls, start by pressing
twice quickly. The international call character
+
appears on the display, which informs the
network centre to select the country-specific
international prefix. Enter the country code,
area code and the subscriber number.

Press to dial the phone number.

When the phone number disappears and the
text
Call 1
is shown, the call is connected.
Wait for the answer, then speak.
Note:
The microphone and earpiece are on the
other side of the device.
When a call is active, you can use the and
keys to lower or raise the volume level of the
phone interface’s earpiece.
Receiving a call
When somebody is calling you, the communica-
tor will give a ringing tone and the text CALL on
the display will flash. If you have selected silent
service within Menu 10, only the keypad and dis-
play lights will flash. If you have selected BEEP,
only a single beep will be heard. If the caller can
be identified, the caller’s phone number (or name
if stored in memory) and the text CALLING will be
displayed instead.
You can answer the call any time, even while us-
ing the memory or menu functions.
To answer an incoming voice call, press or
any other key except or .
If you do not want to answer the call, simply
press . The caller will hear the alerting tone
change to a busy tone.
daphne.frm Page 3 Wednesday, January 15, 1997 5:06 PM