EasyManua.ls Logo

Nokia RM-497 - Test Procedure-Phoenix Service Software Set up; Bluetooth Self Tests

Nokia RM-497
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Test Test Coverage Repair Solution
Bluetooth Self Test:
ST_LPRF_IF_TEST
Bluetooth-FM ASIC UART
interface (controls Bluetooth and
FM receiver and transmitter)
Replacement of BOB module (or
repair of phone BB)
Bluetooth Self Test:
ST_BT_WAKEUP_TEST
Bluetooth ASIC interrupt control
interface
Replacement of BOB module (or
repair of phone BB)
Bluetooth Self Test:
ST_LPRF_AUDIO_LINES_TEST
Bluetooth ASIC PCM interface Replacement of BOB module (or
repair of phone BB)
Bluetooth Functional Test: BER
test with BT-Box or functional test
with other Bluetooth device
Bluetooth antenna circuit Repair of Bluetooth antenna
circuit (including RF filter if
fitted)
FM Radio Functional Test: Perform
scan for local radio stations and
check station list displayed on
phone
FM receiver antenna circuit Repair of FM antenna circuit
(between BTHFM ASIC and
headset connector)
FM Radio Functional Test: Listen to
local radio station
FM receiver audio circuit Repair of FM receiver audio
circuit (between BTHFM ASIC and
headset connector)
The self tests run from Phoenix software are used for fault diagnosis.
If Phoenix software is not available the functional tests with phone accessories are sufficient to verify the
functionality Bluetooth and FM radio receiver and transmitter.
If radio reception is poor inside the service centre buildings, the FM receiver can be tested using another FM
transmitter device connected to a music player.
Test Procedure--Phoenix Service Software Set up
Bluetooth Self Tests
Context
A flash adapter (or phone data cable) connected to a PC with Phoenix service software is required.
Steps
1. Place the phone in the flash adapter or connect data cable to phone.
2. Start
Phoenix
service software.
3. Choose File Scan Product .
4. From the Mode drop-down menu, set to Local.
5. Choose Testing Self Tests.
6. In the
Self Tests
window check the following Bluetooth tests:
ST_LPRF_IF_TEST
ST_LPRF_AUDIO_LINES_TEST
ST_BT_WAKEUP_TEST
7. To run the test, click
Start
.
RM-497
BTHFMTXRDS3.0b
Issue 1 COMPANY CONFIDENTIAL Page 6 – 7
Copyright © 2010 Nokia. All rights reserved.

Table of Contents

Related product manuals