Nordson AD-31 Series - Parts; Using the Lllustrated Parts List; Lntroduction

Parts 8-1
Section
I
Parts
1. lntroduction
Using the
lllustrated Parts List
,,$,
To
order
parts,
callthe Nordson Customer
Service Center at
8OO-241-8777 or
your
local Nordson representative. Use this
five-column
parts
list,
and
the accompanying illustration, to
describe and locate
parts
correctly.
Numbers in the
ltem
column
correspond to numbers that identify
parts
in
illustrations
following each
parts
list. The code
NS
(not
shown)
indicates
that a listed
part
is not illustrated. A dash
(-)
is used
when
the
part
number applies to all
parts
in the illustration.
The
six-digit
number in the Part column
is the Nordson Corporation
part
number.
A dash in this column
(-)
means the
part
cannot be ordered
separately or refers
you
to the
appropriate
parts
list.
The Description column
gives
the
part
name, as well as its dimensions
and other
characteristics
when
appropriate.
lndentions show the
relationships between assemblies, subassemblies, and
parts.
.
lf
you
order the assembly,
items
1 and
2 will be included.
o
lf
you
order item 1, item
2 will be included.
o
lf
you
order
item 2,you will receive item 2 only.
The number in the
Quantity
column
is
the
quantity
required
per
unit,
assembly, or subassembly.
The code AR
(As
Required) is used if the
part
number is a bulk
item ordered in
quantities
or if the
quantity per
assembly
depends on the
product
version or model.
Letters in the Note column refer to notes at the
end
of
each
parts
list.
Notes contain
important information about usage and ordering.
Special
attention should
be
given
to notes.
Item
Part Description
Quantity
Note
1
2
000 000
000 000
000 000
Assembly
.
Subassembly
. .
Part
1
2
1
A
@
1997 Nordson Corporation
All rights
reserved
42-72
lssued 1/97
AsEN{!9-[AD-31EX]-1