7-6
Repair
oo
so
so
4203053
Thermostat Replacement
Fig. 7-9 Connecting
the
Thermostat
Wires
4. Replacing the Heater
Cartridge
Items Needed
7. Discard
the thermostat and install the replacement thermostat.
8. Connect
the thermostat
wires to
the terminal block.
9. Replace
the
pivot
sleeve shells.
lnsert
and tighten the screws holding
the shells together.
10. Restore
the system to
normal operation
by
following
the startup
instructions
in
your
applicator
product
manual.
WARNING: Allow only
qualified personnelto perform
the
following tasks. Read and follow the safety instructions in this
document and all other related documentation.
WARNING: Hot! Risk of burns.
Wear
long-sleeved,
heat-protective clothing; safety
goggles;
and heat-protective
gloves.
o
appropriate
protective
clothing
'
3-mm
ltls-in.1flat-bladescrewdriver
.
3-mm
(1/8-in.)
Phillips screwdriver
o
replacement
heater cartridge
(for
a
part
number,
refer to Parts,
section
8)
ATEN{8-[AD-31EXl-l
42-72
lssued 10/95
O
1995 Nordson Corporation
All rights reserved
To Next Page
Loading...
