Nordson AD-31 Series - Removing the Swivel Bearing

Repair
7-15
4203031
Fig.7-21
Removing the Swivel
Connector Screws and
Washers
4205032
Fig.7-22 Removing the Swivel
Connector and Conical
Spring
4203033
Fig. 7-23 Removing the Retaining
Ring
Removing the Swivel
Bearing
9. Use a 3-mm
(176-in.)flat-blade
screwdriver, and
remove the two
screws and washers
holding
the
swivel connector
to the
pivot
sleeve.
10.
Remove the
swivel connector and
conical spring from the
pivot
sleeve.
11. Remove the retaining ring from the thrust
bearing using snap-ring
pliers.
@
1995 Nordson Corporation
All rights reserued
42-72
lssued
10/95
ATEN-08-[AD-31 EX]-1