1-4
Safety
5.
lnstallation and
Electrical
Connections
6. Operation
WARNING: Failure to follow the safety
procedures
can result in
injury or death.
All
electrical,
pneumatic, gas,
and
hydraulic connections and
installations of hot melt equipment may only be carried out
by
qualified personnel.
Be sure to observe
installation instructions for
components and accessories.
Equipment must be
properly grounded
and
fused according to its
rated current consumption
(see
lD
plate).
Cables
which
run outside the unit
must regularly be checked
for wear
or damage.
Power
supply
wire
gauge
and
insulation must be sufficient to
handle
rated current
consumption.
Cables must never be squeezed or
pinched.
Do not locate
cables or
hoses in high traffic areas.
The
unit should be operated by
qualified personnel
in accordance
with
the instructions
presented
in this document.
WARNING: Failure to follow the safety
procedures
can result in
injury
or death.
Never allow the unit
to
be operated by
personnel
under the influence
of substances which reduce their
reaction times, or who are
not able
to operate the equipment for
physical
reasons.
Prior to each start-up of the unit, check
protection
and warning
devices and make sure they are
fully functional. Do not operate
the
unit if these devices are not functioning
properly.
When the removal of safety equipment
is required for installation,
maintenance, or repair of the unit, it must be re-connbcted
immediately upon completion of the work.
Prior to start-up of the unit, check
to make sure all safety
guards
and
safety equipment
are
in
place
and functioning
properly.
a
a
a
a
a
a
a
a
AIEN-02-[XX-SAFE]-2 42-72
lssued 11/94
O
1995 Nordson Corporation
All rights reserved
To Next Page
Loading...
Need help?
General
