1-6 Safety
Danger of Burns
Contact with hot melt materials
or hot areas of the unit may
produce
a
severe skin
burn.
WARNING: Hot! Risk
of burns. Wear heatprotective clothing,
safety
goggles,
and/or heat-protective
gloves
depending on
the
symbols shown.
Be extremely
carefulwhen using hot melt material. Even solidified
material may
still be
very
hot.
Always wear
protective
clothing which safely covers all exposed
parts
of the body.
ln case
of burns:
o
lmmediately
cool
affected skin areas using cold, clean
water,
o
Do
not forcefully
remove hot melt materialfrom the skin.
o
lmmediately
seek medical attention.
Allow only
qualified personnel
to
perform
the
procedures
described in
this
document. When
performing
such tasks, wear
protective
clothing, and
equipment.
WARNING: Even when
the circuit breaker or
main
power
switch
is OFF, the unit is still electrically energized. Complete
the
following
steps
prior
to maintenance or repair:
Disconnect,
lock out, and
tag
external
power
supply
To ensure
the external
power
supply is disconnected, attempt to
operate
the unit. lf the unit does not energize,
proceed
with
maintenance or repair work.
lf the unit
energizes,
repeat
the disconnect, lock out, and tag
procedure.
Re-test
the unit.
t
a
7. MaintenancelRepair
a
a
a
Al EN-02-[XX-SAFEI-2
42-72
lssued 11/94
O
1995 Nordson Corporation
All rights
raserved
To Next Page
Loading...
