Nordson AD-31 Series - Page 27

lnstallation
3-l
Section
3
lnstallation
1. lntroduction
2.
Unpacking and
lnspection
3.
Connecting the Handgun
to the Hose
Items Needed
WARNING: Allow only
qualified personnelto perform
the
following tasks. Observe and follow the safety
instructions in
this
document and all other related documentation.
This section
provides
unpacking, safety, and installation
information for
installing
Series
AD-31 handguns.
Take care
to
prevent
equipment damage during unpacking
After
unpacking the
handgun, inspect it for the following
1. lf there is a discrepancy between the order and
equipment received,
contact
your
Nordson
representative.
2.
Check the
handgun and hose for dents, scratches, or other
physical
damage. lf there is any
physical
damage,
contact
your
Nordson
representative.
3. Remove foreign material in the service-block air and
fluid
ports.
WARNING: Hot! Risk of burns.
Wear
heat-protective
clothing,
safety
goggles,
and heat-protective
gloves.
appropriate
protective
clothing
3-mm
(1/s-in.)
flat'blade screwdriver
3-mm
117r-;n.)
Phillips screwdriver
20-mm
1s/4-inl
wrench
1
8-mm
(11/15-in.)
wrench
@
@
@
@
1995 Nordson
CorpoElion
All rights reserved
42-72
lssued
10/95
A3EN-0'I-[AD-31EX]-1