lnstallation
3-13
GND
420902s
Fig. 3-19
Connectingthe Ground
Wire
t
42030s1
Fig. 3-20 Connecting the Electrical
Switch
(if
applicable)
Connecting the Heater
@ontd.)
WARNING: Electrical shock hazard exists if
hose
ground
wire
is not secured
tightly to the
gun
body.
5.
lnsert
the
ground
wire, extending from
the
hose, into the screw hole
on the RTD side of the
pivot
sleeve. Secure the wire by replacing
and tightening the screw. Do not overtighten.
CAUTION:
When replacing
the
pivot-sleeve
shells, do
not
pinch
wires
between the shells and the
pivot
sleeve.
An
electrical short can occur if wires are
pinched.
6. Replace
the
pivot
sleeve
shells
and
secure with screws.
Electrical
Switch Connections
(if
applicable)
7.
lf
your
handgun has an electrical switch follow steps a and b to
connect the switch:
a. Find the orientation lug on the hose-cordset connector and
ensure
that the connector and switch
plug
at
the
bottom of the handgun's
handle are
properly
aligned.
b. Attach the switch
plug
assembly at the bottom of the handle to
the
connector on
the
hose
cordset.
8.
Follow
the
hose
installation instructions in
your
applicator
product
manual to connect the hose to the applicator.
@
1995 Nordson Corporation
All rights resaruad
42-72
lssued 10/95
A3EN-04-[Ar]-31EXl-1
To Next Page
Loading...
