38 Chapter 2 Customizing the client
311644-J Rev 00
SkipAutoDial=1 If set to 1, the autodial application is not added to the
Run key in the Registry so autodial must be started
manually by launching autoext.exe. The default is 0
and the application is added.
SkipAutoDialPrompt = 1 If set to 1, the AutoConnect process closes the
Dialup and Extranet Connections that were launched
automatically through the AutoConnect process. The
user is not asked, and the connection closes
automatically. If set to 0, a prompt appears by default
asking whether the Extranet and Dialup connection
should be closed.
SkipBindCheck=1 If set to 1, the binding check is skipped. The binding
check verifies that fewer than four adapters are
bound to TCP/IP when adding the Extranet Adapter.
The default is 0 and the binding check occurs.
SkipLicenseAgreement If set to 1, the License Agreement screen is skipped.
This option is used with other commands described
in the section “Installation modes and options” on
page 39. This screen can only be hidden in Silent
mode if the switch is set. It will be ignored in GUI
mode.
IMPORTANT: By suppressing presentation of the
Nortel Software License Agreement you agree to
accept the terms of the agreement on behalf of the
users receiving the client software from you. The
Nortel Software License agreement can be found on
Page 3 of this document or the package containing
the client software and documentation CD.
If you do not wish to accept the license terms on
behalf of the users, then do not suppress
presentation of the agreement.
Note: SkipLicenseAgreement is not available from
the command line.
SkipScreens=1 If set to 1, all installation screens, except the License
Agreement, are skipped and the client is installed
with default settings. If set to 0, installation screens
are not skipped, and you can customize the
installation. The default is 0 and the screens appear.
Table 4 [Options] section and keyword settings for setup.ini file (continued)
Field Description
To Next Page
Loading...
