When using the Nova Multitimbrally set the Global MIDI channel to a MIDI channel not being used buy one of the parts as incom-
ing program change messages on the Global MIDI channel will change the Performance itself.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
Page 2 looks like so:
As can be seen the higher parameter is “Sysex transmission”. In this case with a value of Single Program.
This parameter selects the type of data to be dumped via MIDI. Use the lower Fast Data knob to adjust this parameter. Whatever
value is set on the lower line of the display is transmitted when the MIDI button is pressed in the Part edit section. The range of
this parameter is Single program,All programs, Single prog request, All progs request, Single performance, All performances,
Single perf request, All perfs request, Single arp pattern, All arp patterns, Single patt request, all patts request, Global parameters,
Globals request, Total data, Total data request, Program bank A, Program bank B, Program bank A request, Program bank B
request, Performance bank A & Performance bank A request. This parameter is memorised as Global.
The Nova can accept System Exclusive dumps while in any mode.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
Page 3 looks like so:
As can be seen the higher parameter is “Sysex Reception”. In this case with a value of Normal (Rx as sent).
This parameter determines if incoming Sysex data will be received & if it is Bank dumps, where it will be stored. Use the lower Fast
Data knob to adjust this parameter. If this parameter is set to “Normal (Rx as sent)” the system exclusive is enabled & any incom-
ing bank dumps will be stored in the same location as they were sent. i.e. a Prog bank A dump will be stored in Prog bank A. If this
parameter is set to “All progs to bank A” any incoming Program bank dump will be written into Program bank A regardless of their
original location. All banks of Programs are accounted for. If this parameter is set to “All perfs to bank A” any incoming
Performance bank dump will be written into Performance bank A regardless of their original location ( this is primarily for use when
dumping from a Supernova ). All banks of Performances are accounted for. If this parameter is set to “Disabled” no sysex will be
received. The range of this parameter is Disabled, Normal ( Rx as sent ), All progs to bank A, All progs to bank B & All perfs to
bank A. This parameter is memorised as Global.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
To Next Page
Loading...
