MODE SECTION
The Incoming Control Change filter does not filter Bank select messages. ( CC00 & CC32 ) These can be filtered using the
Incoming Program Change filter if required.
Page 13 looks like so:
As can be seen the parameter is “Incoming program change”. In this case with a value of Enabled.
This parameter determines if the Nova responds to incoming MIDI program change messages or not. Use the higher Fast Data
knob to adjust this parameter. When this parameter is set to Enabled any Program Change messages sent on Bank 0 will refer to
the Program Map. This can be overridden by sending Bank & Program Change messages to a different Bank. Refer to page 130
for details on the Bank messages received by Nova. When this parameter is set to Program map any Program Change messages
will always refer to the Program map table regardless of any Bank messages that have been received. When this parameter is set
to Disabled, Bank & Program Change messages ignored. This filter is global & applies to all modes. The range of this parameter is
Enabled & Disabled. This parameter is memorised as Global.
If the Incoming Program Change filter is set to Disabled it also filters out Bank select messages ( CC00 & CC32 ).
Page 14 looks like so:
The higher parameter is “Prog change TX”. In this case with a value of On.
This parameter determines if the Nova transmits MIDI program change & Bank messages when a new Program or Performance is
selected ( This includes program changes within a Part of a Performance ). Use the higher Data knob to adjust this parameter. In
the On position whenever a new Program or Performance is selected the appropriate Program change message & Bank message
is sent on the appropriate channel. In the Off position no Program change or Bank change messages will be transmitted. The
range of this parameter is On & Off. This parameter is memorised as Global.
The lower parameter is “Controllers TX”. In this case with a value of On.
This parameter determines if the Nova transmits MIDI Controller messages. Use the lower Data knob to adjust this parameter. In
the On position whenever a knob, slider or switch is manipulated appropriate Controller messages are sent on the appropriate
channel. In the Off position no Controller messages will be transmitted. The range of this parameter is On & Off. This parameter is
memorised as Global.
This does not affect transmission of Bank select controllers when selecting new Programs / Performances or the transmission of
Modulation Wheel.
To Next Page
Loading...
