EFFECTS SECTION
Page 2 looks like so:
As can be seen the higher parameter is “EQ treble”. In this case with a value of +04.
This parameter adjusts the Treble of the selected Program. Use the higher Fast Data knob to adjust this parameter. The range of
this parameter is -64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a Program or
Performance in Performance Mode depending on the value of the Part’s “Effects Used” parameter.
As can be seen the lower parameter is “EQ bass”. In this case with a value of +04.
This parameter adjusts the Treble of the selected Program. Use the Lower Fast Data knob to adjust this parameter. The range of
this parameter is -64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a Program or
Performance in Performance Mode depending on the value of the Part’s “Effects Used” parameter.
Page 3 looks like so:
As can be seen the higher parameter is “Comb frequency”. In this case with a value of 069.
This parameter adjusts the Frequency range of the Comb Filter. Use the higher Fast Data knob to adjust this parameter. The range
of this parameter is-64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a Program or
Performance in Performance Mode depending on the value of the Part’s “Effects Used” parameter.
No effect will be heard when altering this parameter if the Comb Boost parameter is set to 00
As can be seen the lower parameter is “Comb boost”. In this case with a value of +10.
This parameter adjusts the amount of boost to harmonics the Comb Filter provides . Use the Lower Fast Data knob to adjust this
parameter. If this parameter is set to the mid position ( 00 ) no effect will be heard. If turned Clockwise or anticlockwise from this
position boost will be applied to harmonics in the sound. The range of this parameter is-64 to +63. This parameter is memorised
with a Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of
the Part’s “Effects Used” parameter.
Page 4 looks like so:
As can be seen the higher parameter is “Fx config”. In this case with a value of D + R + C.
This parameter changes the order/arrangement of the Delay, Reverb & Chorus/Flanger/Phaser effects. Use the higher Fast Data
knob to adjust this parameter. Different configurations can make the effects sound quite different. i.e. a sound that is delayed then
reverbed & then chorused sounds quite different to a sound that has been Chorused then Delayed then Reverbed. There are 19
different effects configurations available in the Nova. Below is a diagram showing how the “Normal” effects configuration.
Fx config D + R + C
Config morph +1O
To Next Page
Loading...
