When this button is pressed the display shows:
As can be seen the higher parameter is “Part semitone”. In this case with a value of +07.
This parameter Transposes the Program by the number of semitones selected using the higher Fast Data knob. The range of this
parameter is -24 to +24 semitones. This parameter is memorised with the Performance.
As can be seen the lower parameter is “Part detune”. In this case with a value of +25
This parameter Detunes the Program by the amount selected using the higher Fast Data knob. The range of this parameter is -64
to +63 cents. This parameter is memorised with the Performance.
Velocity - Button
This button only works in Performance mode.
This button assigns which Velocity curve is assigned to the currently selected Part. When this button is pressed the display shows
parameters relevant to this section.
When this button is pressed the display shows:
As can be seen the higher parameter is “Part velocity curve”. In this case with a value of Normal.
This parameter determines the velocity response of the currently selected Part. Values are selected using the higher Fast Data
knob. In the “Normal” position the Program plays in a normal velocity sensitive way ( If the Velocity parameter for the selected
Program has been set to any positive value ). In the “Inverse” position the response is inverse to the normal velocity curve. i.e.
Louder sounds are produced by playing softly rather than hard ( If the Velocity parameter for the selected Program has been set to
any positive value ). These two curves are ideal for creating velocity Cross fades between two different parts for Organ type
sounds. The Cross Fade - Low & Cross Fade - High options are similar but provide a “Normal” overall response when used togeth-
er in two different parts. The remaining options provide “Normal” velocity curve response “Up to” or “From” specific Velocity values.
This enables “Velocity Switch” arrangements to be easily made by setting up appropriate curve on two parts. i.e. To Value 100 on
one Part & From Value 101 on another. The range of this parameter is Normal, Inverse,Cross fade - High, Cross Fade - Low, To
Value 60, From Value 61, To Value 70, From Value 71, To Value 80, From Value 81, To Value 90, From Value 91, To Value 100,
From Value 101, To Value 110 & From Value 111. This parameter is memorised with the Performance.
Part velocity curve
Normal
Part semitone +O7
Part detune +25
PART EDIT SECTION
97
To Next Page
Loading...
