NUM 1040 W User Manual

en-938821/2 6 - 15
Operational Problems
6
6.5.2 No Block Sequencing, "INCYC" Indicator Absent
Failure symptoms
Automatic or dry run mode selected.
The movements stop at the end of the block.
The "INCYC" indicator is absent from the status window.
Trouble-shooting
Restart machining by
pressing the "CYCLE"
button on the
machine panel.
Check whether a change
in machining mode has
been requested.
Mode change
?
Yes
No
No
Yes
The programme execution
is finished.
Yes
No
Programmed machining
stop: carry out the expected
intervention.
Is the
M02 indicator
displayed
?
Is the
M00 indicator
displayed
?
1

NUM 1040 W Specifications

General

Brand	NUM
Model	1040 W
Category	Controller
Language	English