NuVinci Nfinity 330 - Nfinity Hub Interface Compatibility & Orientation

11
EN
TECHNICAL OWNER MANUAL
D
B
NFINITY ASSEMBLY OF COMPONENTS
6.6 Harmony
TM
Hub Interface
Compatibility & Orientation
1. Ensure you have the correct Nfinity Hub
Interface for your NuVinci Optimized
CVP.
• N330
TM
CVPs have a yellow dot (A), and
are compatible with Nfinity 330 Hub
Interfaces designated with a light grey
interior (B).
• N360 and N380 CVPs have a black
colored shift driver (C), and are compatible
only with Nfinity 380 Hub Interfaces
designated with a black interior (D).
2. Use the uninstalled Nfinity Hub Interface (E)
to determine the desired orientation
• Typical orientation is forward, parallel to
the chain stay or seat stay cable routing.
• Move the Nfinity Hub Interface along the
dropout to ensure clearance at different
axle positions.
3. With the Nfinity Hub Interface oriented
correctly inside the right dropout, the
installation angle (F) is the indicated
angle of the dropout (20 degrees in this
example).
• Use the markings on the Nfinity Hub
Interface to determine your approximate
installation angle.
3.3 Nfinity
TM
Hub Interface Compatibility
& Orientation
N330 and N360/N380 series
CVPs have different shift driver
configurations, and are compatible
only with the appropriate Nfinity Hub
Interface. Do not attempt to fit incorrect
Nfinity Hub Interfaces, as damage will occur.
C
compatible
compatible
incompatible
incompatible
E
0°
F
0°
20°

!
Nfinity 330 Hub Interface
Nfinity 380 Hub InterfaceN360/N380 CVP
A
N330 CVP