13
EN
TECHNICAL OWNER MANUAL
3.5 Installing the Shifter
1. Install right brake lever according to the
manufacturer’s instruction.
2. Slide the shifter (A) onto the handlebar.
3. Install the right hand grip (B) onto the
handlebar according to the manufacturer’s
instructions
4. Position the shifter such that the display (C)
is visible to the rider and the cable will be
unobstructed
• Tighten the clamp bolt to 2.0-2.5 Nm (18-
22 in-lbs).
Never use lubricants or solvents to
install handlebar grips.
Make sure that the shifter and the
brake lever function properly and are
unobstructed (re-adjust if necessary).
Never ride without the handlebar
grips. The turning grip of the shifter
could become loose. This can result
in a severe injury.
NFINITY ASSEMBLY OF COMPONENTS
C
A
B
A
B
C
!
!
!
To Next Page
Loading...
