Oceanic Prodigy - Informational Displays; Depth Display; Time Display

20
Fig. 17 – Display layout
®
FT
M
a.
b.
c.
d.
INFORMATIONAL DISPLAYS
Each PRODIGY numeric or graphic display represents a unique piece of
information. The following section describes each display in detail.
Depth Display
The top portion of the LCD (Fig. 17a) contains the current Depth display.
The dive number display replaces the depth display in the Surface or Dive
Log modes. Maximum depth is displayed in the lower left portion of the LCD
(Fig. 17c). A current decompression stop ceiling depth replaces max depth in
the decompression dive mode. These displays indicate depths from 0 to 250
feet (0 to 76 meters) in 1foot (.5 meter) increments.
Time Display
The center of the LCD (Fig. 17b) contains the Time display indicating
elapsed surface time, theoretical dive time available, no-decompression dive
time remaining, or total decompression stop time. Elapsed dive time, decom-
pression time for the current stop, or total dive time is displayed in the lower
right portion of the LCD (Fig. 17d). Displays are shown in hour:minute
format (i.e. 1:06, one hour and six minutes not 106 minutes!). The colon that
separates hours and minutes blinks once per second when the display is in
“real time.” Elapsed Surface Time and Bottom Time are real time displays.
Dive Time Available or Remaining are calculated projections of time and use
a solid (non-blinking) colons. This helps you tell the different time displays
apart.