50
Returning the Module To Its Boot
1. Replace the rubber spacer into the boot, if previously removed.
2. Orient the module over the hole in the boot, and dip the bottom edge into
the hole while pressing the top edge with the palm of your hand. Stop
pressing when the bottom edge has just entered the rubber boot.
3. Correct the alignment of the module as needed so that it is straight.
4. Press the module completely into place with your thumbs, watching the
alignment, until it “snaps” into place.
Final Inspection
1. To ensure that the battery installation was successful, activate the unit
and watch carefully as it performs a full diagnostic and battery check.
Initially, the display will display all 8's, with the TLBG loading down until
the unit enters Surface Mode, followed by the Pre Dive Planning Sequence
(PDPS). If Low Battery is indicated, return the unit to your Authorized
Oceanic Dealer for a complete inspection before attempting to use it.
2. Observe the LCD display to ensure it is consistently clear and sharp in
contrast throughout the screen. If there are any portions of the display
missing or appearing dim, return the unit to your Authorized Oceanic
Dealer or Oceanic Parts & Service to receive factory service.
To Next Page
Loading...
